12 Steps to Program the Travel on a LiftMaster Chamberlain Garage Door Opener equipped with MyQ

12 Steps to Program the Travel on a LiftMaster Chamberlain Garage Door Opener equipped with MyQ

1. Make sure your garage door is closed but not disengaged and your trolley is near the garage door.

   

2. Find your garage door opener adjustment buttons. Their place may vary depending on your LiftMaster or Chamberlain garage door opener model. Look at the picture below to help you out.

   

3. Press and hold the black square button until the UP Arrow begins to flash or you hear a BEEP > This means your opener can now be set in the OPEN POSITION.
4. Press and hold the UP or DOWN Arrows until your garage door is fully open > This is your desired UP Position.
5. Press and release the black square button > The garage door opener lights will flash 2 times and the DOWN Arrow will start to flash. It means your opener OPEN POSITION is now LOCKED and your door opener is ready to set the CLOSE POSITION.
6. Press and hold the DOWN Arrow until your garage door is fully closed.
7. Press and release the black square button to indicate to your opener that your garage door is in the DOWN position you desire > The garage door opener lights will flash 2 times and the UP Arrow will start to flash. It means your opener DOWN POSITION is now LOCKED and your door opener is ready to set the force programming mode.
8. Press and release the UP Arrow. When the door travels to the programmed UP position, the DOWN Arrow will begin to flash.
9. Press and release the DOWN Arrow. The door will travel to the programmed DOWN position. Programming is now complete.

   GOOD TO KNOW

   • If the garage door opener lights flash 5 times during the steps to Program the Travel on a MyQ Garage Door Opener, the programming has timed out.
   • If the garage door opener lights flash 10 times during the steps to Program the Travel on a MyQ Garage Door Opener, the safety reversing sensors are misaligned or obstructed.
   • After aligning or clearing the sensors, do a complete up and down garage door cycle using your remote control. Programming will be complete.
   • The yellow round button is only used to program your garage door accessories. Never-ever use it for programming your opener travel.
10. You’re not done yet! After you do ANY adjustments on your garage door opener, the safety reversal system MUST be tested. Here is how the company US Inspect recommends to do it.
11. Using your remote control, your smartphone or your keypad, close your garage door.
12. Your garage door must reverse when stricking the 2x4.

https://www.garaga.com/