HOW TO PROGRAM A GENIE REMOTE CONTROL
When you purchase a Genie ReliaG ProSeries 2028 garage door opener, you receive a remote control that has been conveniently pre-programmed to work with the opener. If you bought additional remote controls separately, or if you wish to re-program your remote, follow these steps.
Keep in mind that each programming step has a 30-second time limit for completion, after which the step needs to be restarted. A step can be restarted as many times as needed.
- If it’s a new remote, remove the battery’s protective film by pulling it straight out.
- Press and hold the program button for two seconds until the round LED turns blue, then release. Next the long purple LED will flash.
- Press and release the remote button twice. The LEDs on the opener will flash, indicating it has been programmed to the remote.
That’s all there is to it. Press the button on the remote again and the garage door will open and close.
https://www.creativedoor.com/