HOW TO PROGRAM A LIFTMASTER MAX REMOTE CONTROL
LiftMaster MAX remotes work with all 315 MHz or 390 MHz LiftMaster garage door openers manufactured since January 1993 (that is, all LiftMaster, Chamberlain, and Sears Craftsman openers that have a green, orange, red, purple or yellow learn button and a yellow antenna wire). Follow these steps to program the various MAX models.
- Locate the "Program" button on your garage door opener or keypad.
On the 890MAX and 895MAX remotes, locate the "Program" button and press it using a safety pin or paper clip until the LED on the front of the remote control turns on. It will then be ready to program.
On the 893MAX remote, locate the "Program" button on the back of the device located under the visor clip. Press the button to activate it.
On the 877MAX keyless entry keypad, press the * and # buttons simultaneously until the lighted keys stop flashing and remain on steady.
Note that when the controller is in programming mode, you need to program one button at a time. - Press and release the button on the remote control that you wish to program.
- Wait for the remote control LED to stop blinking, then slowly press and release the button again. Repeat until the light bulb blinks.
Don’t press the button after the light bulb blinks as this will prompt the remote to transition into a different setting, rendering it inoperable. If you do press the button, you will need to go through the steps again from the beginning. - Once the light bulb blinks, press any other button on the remote control.
To program other buttons on the remote control, repeat steps one to four.
https://www.creativedoor.com/